Company Profile

Natural Gas Flow Meters and Compressed Air Flow Meters for Plant Energy Auditing and Leak Profiling

Quick Answer: A thermal mass flow meter is the first choice for compressed air and natural gas energy audits from DN15 to DN250. It gives direct mass flow in kg/h or Nm3/h plus 4-20 mA HART output for leak logging. Send your pipe size, pressure, temperature, and flow range to Silver Instruments for a specific model and quote.

Contact: Tel: +86-25-68650347 | WhatsApp: +86-25-52155837 | WeChat: +86 15365082610

Why a Flow Meter Belongs in a Plant Energy Audit

Compressed air leaks are easy to ignore until someone logs the header flow at night. In practice, plants in Vietnam and Thailand often lose 15 to 25 percent of compressed air to small leaks. A plant in Thailand found 18 percent of its compressed air was escaping from leaks and open drains. The maintenance team only checked pressure before the audit. Pressure looked normal. The flow meter showed the real loss.

Natural gas is similar. A boiler fuel line without a flow meter cannot show true energy use per batch. A thermal mass flow meter on a DN50 gas line reads kg/h directly. Because the meter measures mass flow, there is no need for separate pressure and temperature compensation in most cases.

Here is the thing. Leak profilers need flow data over time. A single pressure reading will not show a slow leak. A flow meter plus a paperless recorder gives the trend and the totalized loss.

Recommended Meter Types for Compressed Air and Natural Gas

The Silver Instruments SIL-TMF100 thermal mass flow meter is the standard starting point for plant air audits. It covers DN15 to DN300, supports inline and insertion mounting, and works up to 60 bar. The signal board offers 4-20 mA HART, RS485 Modbus, and pulse output. The local display shows kg/h, Nm3/h, totalized flow, and gas temperature.

For natural gas at higher pressure, the SIL-VF200 vortex flow meter works on DN25 to DN150 lines. It is a good fit for gas pressure from 1 to 40 bar and steady flow. But a vortex meter loses accuracy at very low flow. If your boiler idles at 5 percent of full load, a thermal mass meter is usually the safer pick.

Coriolis mass flow meters from Silver Instruments are the premium option for natural gas blending or custody transfer. They are accurate but cost more. Most plant energy audits do not need that level. A thermal mass meter with 1.5 percent accuracy is enough for leak profiling and consumption logging.

Parameter Examples from Customer Sites

A paint manufacturer in Southeast Asia asked us for a compressed air flow meter on a DN80 header at 7 bar. Normal flow was 400 Nm3/h. We supplied an insertion SIL-TMF100 with 4-20 mA HART and a local totalizer. The first weekend of logging showed a 12 percent leak in the ring main.

Last year a customer in Vietnam asked us to log compressed air flow for 72 hours on a DN100 pipe. The pressure was 6 bar. The temperature was 28 °C. We recommended a thermal mass flow meter with built-in data logging. The audit showed two large leaks near an old air receiver.

A textile plant in Indonesia needed natural gas measurement on a DN50 boiler line. Gas pressure was 0.8 bar, temperature 30 °C, and flow range 60 to 500 kg/h. We quoted the SIL-TMF100 inline thermal mass meter with PT100 input. It reads mass flow in kg/h and totalized gas use for the energy audit.

Installation Notes for Leak Profilers

Install the compressed air meter after the air dryer and filter. That keeps oil and water away from the sensor. A straight run of 10D upstream and 5D downstream is enough for the SIL-TMF100 insertion meter. Vortex meters need more straight run. Check the manual for the exact number.

For natural gas, confirm line size, pressure, temperature, and flow range before ordering. A DN50 meter at 0.8 bar has a different